Kayak Fishing Adventures on Big Water’s Edge - View Single Post

fongman · 01-26-2013, 01:26 AM

When I picked up a Lowrance FF, the shape of the transducer convinced me to try an externally mounted, articulating transducer arm. I used plastic bimini top parts for the pivot points (end caps) and the base (deck hinge). It took a few adjustments to get the correct arm lengths and the proper angle entering the water. The first trials were unsuccessful because at higher speeds, air bubbles would form and cause vertical lines in the display (dropouts).

I'm still not sold on this method because it is more maintenance than a below deck mount. However, it may help give someone ideas for making a portable transducer arm.

01-26-2013, 01:26 AM	#1
fongman Senior Member Join Date: Mar 2005 Posts: 116	Externally Mounted Transducer When I picked up a Lowrance FF, the shape of the transducer convinced me to try an externally mounted, articulating transducer arm. I used plastic bimini top parts for the pivot points (end caps) and the base (deck hinge). It took a few adjustments to get the correct arm lengths and the proper angle entering the water. The first trials were unsuccessful because at higher speeds, air bubbles would form and cause vertical lines in the display (dropouts). I'm still not sold on this method because it is more maintenance than a below deck mount. However, it may help give someone ideas for making a portable transducer arm.