Keep it simple:
Parts:
- 3.5 gallon bucket
- Rule 360 Bilge Pump
- 3/4" clear tubing (long enough to reach from the bucket just under the water line of your yak.
- 3/4" connectors (elbow for inside bucket, female to slip from elbow to tubing and pump
- 6 volt battery stored in dry bag
- tie straps
Labor:
- Cut center out of bucket lid so no trying to remove lid while on yak.
- Drill multiple 1/4" holes in top sides of bucket near scuppers for water drainage.
- Drill 3/4 hole near bottom of bucket for water entry and push connectors through attaching hose to bilge pump.
Easy....you can make on in about a half hour once you have the stuff. If you have a crate you use already, just through the whole thing in there and bungy it down.
-Steve