Transducer Install - Stealth 14 - Kayak Fishing Adventures on Big Water’s Edge

Dirty Curti · 09-17-2012, 12:24 PM

In my Stealth 12 I installed, in the hull, front portion just in front of the bait tank. What I did was to get some plumbers putty and rolled about a 1/4" thick strip of putty and then placed an oval shaped circle in the crevis of the hull and filled it with goop. I then taped the transducer into the pool of goop and put a little weight on it to keep it in place for 24 hours.

Works great! I think the water temp might be off a couple of degrees but otherwise no issues.

09-17-2012, 12:24 PM	#2
Dirty Curti Senior Member Join Date: Jul 2012 Location: Oceanside, CA Posts: 419	In my Stealth 12 I installed, in the hull, front portion just in front of the bait tank. What I did was to get some plumbers putty and rolled about a 1/4" thick strip of putty and then placed an oval shaped circle in the crevis of the hull and filled it with goop. I then taped the transducer into the pool of goop and put a little weight on it to keep it in place for 24 hours. Works great! I think the water temp might be off a couple of degrees but otherwise no issues. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode