help running wire

[MrM]

Originally Posted by TJones

my transducer needs to be in water, so i ran my cable through the scupper hole and now i want to run the cable inside the kayak. if i drill a half inch hole to get cable inside hull , how do i cap it? any suggestions would be appreciated.

What kind of kayak do you have? Marine goop is a good sealer for any very small holes that you make. The OK Trident has a setup similar to what you are describing. Mine came with a little hole for the wire to run right above the "Transducer" sticker in this picture. Not sure if that was stock or the guy before me did it. (bought it used)





Before you do any cutting, make sure you are 300% positive you want a hole in your kayak!