advice for Stealth 12 PVC cart? - Kayak Fishing Adventures on Big Water’s Edge

Dirty Curti · 08-20-2013, 08:44 AM

I also made the same one sdspeed posted. The only difference was I added posts to fit into the scupper holes so it won't shift or spread. I made sure everything fit and worked prior to gluing.

The posts have to be small as the scupper holes are in a slight angle. So I made them just long enough to go into the hole and the hull just lays on the pads.

I posted both carts made by Palmetto in the innovations section. This is the other one.http://palmettokayakfishing.blogspot...ayak-cart.html

08-20-2013, 08:44 AM	#5
Dirty Curti Senior Member Join Date: Jul 2012 Location: Oceanside, CA Posts: 419	I also made the same one sdspeed posted. The only difference was I added posts to fit into the scupper holes so it won't shift or spread. I made sure everything fit and worked prior to gluing. The posts have to be small as the scupper holes are in a slight angle. So I made them just long enough to go into the hole and the hull just lays on the pads. I posted both carts made by Palmetto in the innovations section. This is the other one.http://palmettokayakfishing.blogspot...ayak-cart.html __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode