Hobie PA 12 Minn Kota motor build - Kayak Fishing Adventures on Big Water’s Edge

Montesdad · 05-19-2015, 12:58 PM

Now for the electronics - I cut the wires down the same amount of the post removal, put fresh connections on them and rewired so there wouldn't be so much left over. Drilled a fresh hole for the top mount and put it all back together.

Decided to trim the propeller guard off to help with facilitating removal and insertion into the plug hole. In retrospect, I could have left it on - just seems a bit easier for removal.
I figure I'm not going to be running over any objects and I always have me pedals stowed as a backup.

05-19-2015, 12:58 PM	#5
Montesdad Grey Haired Senior Member Join Date: Apr 2008 Location: So. Orange County Posts: 53	Now for the electronics - I cut the wires down the same amount of the post removal, put fresh connections on them and rewired so there wouldn't be so much left over. Drilled a fresh hole for the top mount and put it all back together. Decided to trim the propeller guard off to help with facilitating removal and insertion into the plug hole. In retrospect, I could have left it on - just seems a bit easier for removal. I figure I'm not going to be running over any objects and I always have me pedals stowed as a backup. __________________ - - - "I'm fishing as hard as I can" - - - Last edited by Montesdad; 05-19-2015 at 07:15 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode