Hobie PA 12 Minn Kota motor build - Kayak Fishing Adventures on Big Water’s Edge

igotpron · 05-19-2015, 02:02 PM

That's a sweet setup man! Very clean!!
If that's the Marineco trolling motor plug, be extra certain the screw in terminals for the wires are good and solid. Yank on them before each use. Mine would loosen and fall out eventually. I opted to solder the wires to the plugs. No easy task. And the nubs on the casette are going to eventually break. When it does replace it with an old shaft from your mirage drive.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-19-2015, 02:02 PM	#10
igotpron Xcoastie Join Date: Jun 2013 Location: Westminster Posts: 285	That's a sweet setup man! Very clean!! If that's the Marineco trolling motor plug, be extra certain the screw in terminals for the wires are good and solid. Yank on them before each use. Mine would loosen and fall out eventually. I opted to solder the wires to the plugs. No easy task. And the nubs on the casette are going to eventually break. When it does replace it with an old shaft from your mirage drive.