Lowrance fish finder wires waterproof? - Kayak Fishing Adventures on Big Water’s Edge

Fishin Phil · 07-23-2016, 05:39 AM

Buy a tube of Dielectric Silicone Compound. It's about ten bucks but it will keep your connectors from getting corrosion on them. I would not rinse the connector because water and electricity do not mix. Besides salt water will not damage the outside of the plug. Reapply as needed and it will keep your wire connector and fish finder connector in top condition.

King Saba · 07-23-2016, 08:41 PM

I've been reading about the dielectric grease. I'll try that out as a safety measure. Thanks.

07-23-2016, 05:39 AM	#1
Fishin Phil Senior Member Join Date: Dec 2005 Location: San Diego Posts: 288	Buy a tube of Dielectric Silicone Compound. It's about ten bucks but it will keep your connectors from getting corrosion on them. I would not rinse the connector because water and electricity do not mix. Besides salt water will not damage the outside of the plug. Reapply as needed and it will keep your wire connector and fish finder connector in top condition. __________________ God, Family, Your Health, You're Fishing.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-23-2016, 08:41 PM	#2
King Saba Senior Member Join Date: Nov 2014 Location: SGV Posts: 848	I've been reading about the dielectric grease. I'll try that out as a safety measure. Thanks.