Permanent Wet Transducer Installation

[WahooUSMA]

Bob,

I just finished my install of the wet transducer (copied yours). Unfortunately, with the Lowrance transducer, you need to use the ABS 4in male adapter vs. 3in adapter. This sucks because one; its quiet a bit larger, and secondly, the 3 in. cap is flexible while the 4in cap is rigid...(sounds kind of West Hollywood-ish).

My only issue is going to be removing the cap to check for water levels. I am afraid I might eventually separate the ABS adapter from the hull since the cap is so rigid and difficult to remove. Also, last question. Did you sanitize the GOOP in the interior of the adapter (seepage) or do you think it matters? I am guessing with all glue and adhesives, as they dry air bubbles appear......what do ya think???

Anyway, thanks for you expertise!