Loose Hobie Fin Rod - Kayak Fishing Adventures on Big Water’s Edge

newguy01 · 12-29-2010, 06:23 AM

check if you still have the ellen type set screw in the plastic housing, that keep the rod in place

Deamon · 12-29-2010, 06:44 AM

Thanks to both of your replies!

dsafety · 12-29-2010, 06:49 AM

From your photo, it does not look like your mast has a notch where the Allen screw is supposed to rest. If this is the case, you may have a defective mast or have the mast installed backwards.

If you do have a notch in the mast, make sure it is aligned with the set screw when you put it back together. Lock Tight or some similar material is recommended for the set screw.

Bob

12-29-2010, 06:23 AM	#1
newguy01 Senior Member Join Date: May 2007 Location: S.D. Posts: 133	pin check if you still have the ellen type set screw in the plastic housing, that keep the rod in place

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-29-2010, 06:44 AM	#2
Deamon Senior Member Join Date: Mar 2010 Posts: 1,972	Thanks to both of your replies!

12-29-2010, 06:49 AM	#3
dsafety Olivenhain Bob Join Date: May 2008 Location: Olivenhain, CA Posts: 1,122	From your photo, it does not look like your mast has a notch where the Allen screw is supposed to rest. If this is the case, you may have a defective mast or have the mast installed backwards. If you do have a notch in the mast, make sure it is aligned with the set screw when you put it back together. Lock Tight or some similar material is recommended for the set screw. Bob