Stickers

[blitzburgh]

I have always just made sure the surface area was clean with no oily residues. I haven't had any problems. Sometimes the decal itself will have weak adhesive. In that case, you might want to try adding some spray adhesive.

[bus kid]

Wash the area with Dawn dish soap and dry it thoroughly. Oh and peel off the back of the sticker.

[Matar]

OK OK I fell into that one.
I just did not know if anyone had had problems with them coming off.

[bigFISHINyak]

Here comes a legitimate answer.....no jokes from me this time. I have had multiple hobies and did not have any issues with stickers coming off. The slick surface is perfect for stickers but if you plan to put some on the top rails or anything there might be an issue as the plastic is a little more bumpy and not quite as smooth. Make sure you pick a smooth plastic area so that no air can get between the adhesive and the plastic. Also make sure your stickers are newer and haven't been sitting around for a long time because the adhesive might have gone to crap. The clean surface is a must but that has already been mentioned. Hope this response helps unlike my previous response!

[Matar]

Yah clean surface will be done, i just remember that when i had other water toys water would always get under them and peal them off.
Thank you