HDS Gen 2 need help

[ful-rac]

Originally Posted by Mike scales

I think mine is an insight 50/200khz or 83/200
Mounted on belly of my PA 14.

Ok so Im assuming that mounted on the belly you are referring to, mounted in the lowrance ready bay. So it's not a transducer problem. Can you describe or better yet get a screen shot of what your fishfinder looks like when in use?

[Navyyak]

I selected the correct transducer in the list based on the tag and I have it mounted in the scupper hole made for the lowrance transducers. Most of the time the top half of the screen is just a bunch of clutter and then clears up, I never see any fish arches. I tried messing with every setting, ping, surface clarity, fishing mode, sensitivity and still can't seem to get it right.

[Lipripper92592]

Originally Posted by Navyyak

I selected the correct transducer in the list based on the tag and I have it mounted in the scupper hole made for the lowrance transducers. Most of the time the top half of the screen is just a bunch of clutter and then clears up, I never see any fish arches. I tried messing with every setting, ping, surface clarity, fishing mode, sensitivity and still can't seem to get it right.

Start with the factory default setting...then switch to manual mode. To vision what your FF is showing, start in shallow water, shallow and clear enough so you can see the bottom. Then compare the FF screen to what you are seeing below, adjust ping and "gain" (can't remember the tech name at the moment) to clear the screen with just a few blips on the screen, paddle over some kelp or rocks and check the screen, so you see the kelp/rocks, adjust resolution. See a bait ball on the surface, paddle over and adjust until the bait is shown as a ball or individual fish and the surrounding area is clear, or slightly "hazy".
It's a matter of practice and preference. It's hard to do, but sometimes you have to leave the rod at home and take a trip to just dial in the gear. That way you can focus on equipment setup, launching and landing. Once that is nailed down...bring out the arsenal.
Youtube has some pretty good video's as well.

[Lipripper92592]

Originally Posted by Navyyak

I selected the correct transducer in the list based on the tag and I have it mounted in the scupper hole made for the lowrance transducers. Most of the time the top half of the screen is just a bunch of clutter and then clears up, I never see any fish arches. I tried messing with every setting, ping, surface clarity, fishing mode, sensitivity and still can't seem to get it right.

Check and see if you have sand packed into the transducer area. I was getting crappy readings until I washed all the sand out. I hauled the PA backwards packing the transducer with sand and pieces of kelp.

[ful-rac]

Also remember that your fishfinder will never display perfect fish arches like the demo mode does.

Here's what my FF looks like.

broadband/dsi/sidescan
Baitball



Black seabass & squid



Black seabass & my squidjig gangion