Tips for trolling artificials?

[PescadorPete]

I use a cheap Home Depot Tarp Clip tied on the hull and close to waterline. Less expensive than an outrigger release clip. Rod in holder, line runs down and into the clip. Keeps it close to water and it pops out of the clip on a strike. I usually troll small Rapalas Sinking Magnums #11 and big Krocs with good luck.

I like that rubber band trick, I'll have to give it a try.

[alanw]

I don't use flush mount holders or rocket launchers. Clips or rubber bands I think would put my line too close to the yak and possibly chafe the line or get tangled on something. I use Scotty rod holders set to a horizontal position out and away from the yak. My rod tip is about a foot off the water and six feet out off the side. This way I can watch the rod tip as I paddle and adjust my speed to see the lure action. I can also turn the yak a bit without having the line going under the back of my yak, which would be a bad idea with a rudder. Sometimes I run two rods off opposite sides of my yak which puts the lines about 14 feet apart to help prevent tangles.

[fishnfoool]

Since you have been going after bones and bars, then on the surface is ok. If you want to catch yellowtail, try the lures like the rapalas that have lips to keep them a little above the surface.

[Harry Hill]

I was trolling a spoon in fresh water yesterday, I almost could not paddle slow enough to keep the spoon from coming to the surface. I would stop and let it sink then start paddling again and it would come right back up. I think stop and go is the only option with a spoon.