Transducer Removal - Kayak Fishing Adventures on Big Water’s Edge

wavster · 06-16-2010, 09:05 PM

DO NOT USE A SHARP TOOL!

Be careful with what every you use (No razor blades
or knives). You could easily cut through the bottom
of your kayak.

fongman · 06-17-2010, 08:06 AM

Quote:

Originally Posted by wavster

DO NOT USE A SHARP TOOL!

Be careful with what every you use (No razor blades
or knives). You could easily cut through the bottom
of your kayak.

Are you referring to a putty "knife" as a sharp tool? What I was referring to isn't actually a knife.

peguinpower · 06-17-2010, 09:56 AM

If you used regular non-flexible epoxy on a polyethylene kayak, you maybe able to removed it by hitting it with a rubber hammer from the outside and then spraying it with WD-40. It should pop off after a good soak.

With Goop, the method previously mentioned works well for me.

/bing

MVC · 06-17-2010, 10:08 AM

I have removed them a couple of times by applying a little heat with a heat gun. This works good with Goop but I am not sure about epoxy.

06-16-2010, 09:05 PM	#1
wavster Senior Member Join Date: Feb 2007 Location: Encinitas Posts: 562	DO NOT USE A SHARP TOOL! Be careful with what every you use (No razor blades or knives). You could easily cut through the bottom of your kayak. __________________

06-17-2010, 09:56 AM	#3
peguinpower bing! Join Date: Mar 2007 Location: socal Posts: 246	If you used regular non-flexible epoxy on a polyethylene kayak, you maybe able to removed it by hitting it with a rubber hammer from the outside and then spraying it with WD-40. It should pop off after a good soak. With Goop, the method previously mentioned works well for me. /bing

06-17-2010, 10:08 AM	#4
MVC Senior Member Join Date: Jan 2008 Location: Costa Mesa Posts: 278	I have removed them a couple of times by applying a little heat with a heat gun. This works good with Goop but I am not sure about epoxy.