Mirage Drive Dosent Fit...? - Kayak Fishing Adventures on Big Water’s Edge

Kesepton · 09-07-2010, 11:01 AM

Sorry, kind of having a hard time understanding what youre trying to say.

I got it in yesterday. The sides that stick out the furthest are really tight fit in the drive well, im thinking of shaving it down a little, but worried it may compromise the drive under pressure. What I did instead was loosen the bolts that hold the knobs in so that I could raise them up and then I could turn it to hold the drive in place. These were nearly stripped, but luckily I had a new set, but it was a pain getting the old ones out.

It is secure and it clicks in fine, but its a pain getting my finger in there to lift up the knob to get it to work. I may end up shaving the bottom of it so it has a steeper angle and I can turn it and itll lift it self up and over.

Any thoughts?

09-07-2010, 11:01 AM	#3
Kesepton Member Join Date: Feb 2010 Posts: 70	Sorry, kind of having a hard time understanding what youre trying to say. I got it in yesterday. The sides that stick out the furthest are really tight fit in the drive well, im thinking of shaving it down a little, but worried it may compromise the drive under pressure. What I did instead was loosen the bolts that hold the knobs in so that I could raise them up and then I could turn it to hold the drive in place. These were nearly stripped, but luckily I had a new set, but it was a pain getting the old ones out. It is secure and it clicks in fine, but its a pain getting my finger in there to lift up the knob to get it to work. I may end up shaving the bottom of it so it has a steeper angle and I can turn it and itll lift it self up and over. Any thoughts?