Share Your Innovations - Kayak Fishing Adventures on Big Water’s Edge

Stan K G · 09-24-2010, 10:09 PM

For wet mounting using the black pipe section and rubber cap;

I had to install it in a fairly curved and asymetrical part of my yak, and I neither have the tools nor patience to file the pipe down properly, so I used marine putty.

Took the whole tube to make this...make sure to rough up the pipe very nicely, and to put on more than you need. Set it and put as much pressure as you can on it, let it cure. It will -NOT- hold to the yak plastic so after it cures pop it off and use marine poly glue to get it secure...use glue inside, outside and at the putty/pipe line so it holds and nothing leaks. (if you have it, silicone the threads to further reduce leak)

I also used some marine goop and a 2" section of PVC to mount my submerge type transducer under the rubber cap, forgot to take a pic.

09-24-2010, 10:09 PM	#11
Stan K G Banned Join Date: Sep 2010 Posts: 36	For wet mounting using the black pipe section and rubber cap; I had to install it in a fairly curved and asymetrical part of my yak, and I neither have the tools nor patience to file the pipe down properly, so I used marine putty. Took the whole tube to make this...make sure to rough up the pipe very nicely, and to put on more than you need. Set it and put as much pressure as you can on it, let it cure. It will -NOT- hold to the yak plastic so after it cures pop it off and use marine poly glue to get it secure...use glue inside, outside and at the putty/pipe line so it holds and nothing leaks. (if you have it, silicone the threads to further reduce leak) I also used some marine goop and a 2" section of PVC to mount my submerge type transducer under the rubber cap, forgot to take a pic.