Revo dilemma - Kayak Fishing Adventures on Big Water’s Edge

fongman · 12-19-2010, 09:23 AM

Quote:

Originally Posted by mrJB

Adam -

Hard to say. Slotting the bottom portion (w/relief holes) is much easier but not as clean looking since some of the slot will remain above the existing Hobie holder due to lack of compression where the slot ends.

Grinding down the bottom section of the tube makes for a better looking holder but is labor intensive. Also doesn't leave a whole lot of wall thickness.

Why not use 1.25" tube connected to a 1.25" x 1.5" reducer fitting, then connect the 1.5" T fitting? Use something like corktape to build up the 1.25" tube so that it fits snug in the builtin rodholder. You'll save time and you won't lose any strength. Plus, it will only cost about a couple of bucks.

MVC · 12-19-2010, 01:21 PM

I made this about 1 year ago, saw it at a baytubers tournament. I use 1/4 tubing to go into the kayak connected to a 1 1/4 to 1 1/2 coupler and the rest of the tubing is 1 1/2. No sanding or cutting required and the coupler fits perfectly into the notch at the top of the pole hoder in the revo. If you wanted a tighter fit, you could add cork or something.

12-19-2010, 01:21 PM	#2
MVC Senior Member Join Date: Jan 2008 Location: Costa Mesa Posts: 278	I made this about 1 year ago, saw it at a baytubers tournament. I use 1/4 tubing to go into the kayak connected to a 1 1/4 to 1 1/2 coupler and the rest of the tubing is 1 1/2. No sanding or cutting required and the coupler fits perfectly into the notch at the top of the pole hoder in the revo. If you wanted a tighter fit, you could add cork or something.